Checkout out our frequently asked questions about the Ultrahook below:
Question:
I installed my new Warn Zeon 10k yesterday and the synthetic rope it shipped with a rope thimble that is to wide for my Ultrahook.(says made in USA). Actually doesnt fit the Warn hook correct, with the flair out at the end of the thimble it sets cocked with the pin installed. Looks just like the one in you FAQ section video. Going to look around and contact Warn for another thimble before going the route of pounding the one i have flat enough to use. Cutting off the old one risks damage to the line itself and if you pound the OEM one down you would need to sand down the surface and paint it to avoid scratching up your new Ultrahook where it contacts. I'll get it sorted but worth consideration when purchasing your winch and Ultrahook.
Answer:
Yes, this is a problem WARN is aware of and has implemented a fix for the issue. Thank you for your business and checking our FAQ.
-------
Question:
Is this the best finish then out of all of them? How does the silver hood up?
Answer:
The MilSpec Hard Anodized GRAY finish is the strongest, the silver however will stay looking the nicest over time. You are less likely to see the scratches etc in the finish after it's been used. Thanks!
-------
Question:
Does the UltraHook work with OEM tow hooks? I am debating between this or the Flatlink E but I like the UltraHook for its versatility and hope that it would be useful with OEM tow hooks.
Answer:
Hi Tim,
Depending on the type of OEM tow hook you come across they will work.
Rear "S" hooks or the front tow mounts on a Jeep will work perfectly. The trick you run into is the area the OEM tow point is located needs to have enough space to accept the UltraHook as it's wider and longer than the FlatLink E.
Using an UltraHook with a soft shackle ends up being a winning combination because in most cases you will be able to get your line attached to the vehicle you are trying to assist and also not have to worry about damaging the finish on your UltraHook.
Please let us know if you have any other questions. Feel free to also give us a call at 208-639-1674
Thanks!
-------
Question:
Are you saying the cable ends of Warn winches won’t fit into the Ultra Hook, or did you get it to work?
Answer:
Hi Rob,
Have you checked the FAQ section on our website? We address this under the first questions listed. Please let us know if you have any questions. Feel free to call us anytime 8-5pm M-F MST at 208-639-1674 for more info.
https://factor55.com/faq/ -------
Question:
Does all the "gray" versions have the Military Specification Hard Anodizing (Mil-A-8625 F Type III) ?
Answer:
Yes. That is correct. All gray parts are Military Specification Hard Anodizing (Mil-A-8625 F Type III)